Inspect the valve inlet supply connections for leaks and tighten or replace the connectors.
Ice maker water inlet valve leaking.
You will need to remove the rear panel to access it.
The inlet valve is located at the bottom of the freezer.
The water valve supplying the icemaker is a key component of the icemaking system and it should be the first thing you check if the icemaker s performance is erratic or if the icemaker stops.
If the water pressure is too low the valve may not close fully when the power is shut off.
The water inlet valve supplies water to the refrigerator ice and water dispenser.
Most ice maker supply lines are attached to a shutoff valve or piercing valve located under the kitchen sink.
The water line from the water valve to the ice maker can freeze not letting water into the ice maker.
Where to find the water inlet valve.
Ice machines typically require an air gap which is a space between your ice machine drain line and the floor drain.
If a dish towel or other item manages to lodge itself underneath the floor drain water won t drain properly and will overflow giving the appearance a leak has sprung underneath your ice machine.
Once it s determined that neither of these are the problem you should check the water valve.
A clogged water filter could also cause low or no water flow to the ice maker or the water dispenser.
Repair any leak or replace the leaking part.
Turn the water off at the source and then disconnect the supply line.
Next unplug the ice maker and check the water reservoir for a crack or hole.
Although less of a leak and more of a drainage issue the symptoms are similar which leads customers to believe their ice maker is leaking.
The valve requires a minimum of 20psi to work properly.
If the ice maker leaks water first check for leaks in the house water supply line connected to the water inlet valve the drain line and the drain pump.
It is usually on the rear of the fridge near the bottom.
As a result the valve leaks water into the ice maker causing it to overflow.
Replace the reservoir if it leaks.
If you are testing the inlet valve you must first disconnect the power so it s safe to work on your freezer.
Unplug your refrigerator disconnect the water supply and locate your water inlet valve.